Woodcut Tools Bowlsaver Bowl Coring System

The Woodcut Tools Bowlsaver is money in the bank, allowing you to triple your turning output by getting up to 3 nested bowls from a single large bowl blank. Material that would have otherwise been reduced to shavings can now be turned into two additional bowls that can be sold as the perfect grain-matched set. It works on bowl blanks up to 12” in diameter. The Bowlsaver Bowl Coring system uses a semi-circular cutter to scoop out most of the waste, leaving a perfect blank for another small bowl. This bowl can then also be hollowed in the same way, leaving a third bowl blank. The Bowlsaver is attached to the lathe via the lathe tool post and is also supported by a Morse taper that fits into the tailstock of the lathe. It includes two blades with Stellite cutters that withstand shocks caused by knots and nails producing great results with either seasoned or unseasoned timber. If turned unseasoned, the resulting bowl blanks can be put aside for seasoning and finishing at a later date. Includes 1” Diameter Tool Rest Post.

Woodcut Tools Bowlsaver Bowl Coring System Details:

• Save wood, money and time hollowing out your bowls
• Predictable results every time, with either green or seasoned wood
• Easy setup uses both the tool rest and tail stock on your lathe
• Includes two high-strength knives with Stellite Cutters
• Removes bowls from 3” to 12” in diameter, and up to 5” deep from inside the mother bowl
• Use on lathes with a swing from 12” to 16”, and a motor of 1HP or greater
• Stellite cutters provide a fine finish and excellent durability on hard and soft woods
• Includes 1” diameter Tool Rest Post, detailed user guide and ready-to-use planning templates to successfully core a nest of bowls

NOTE: A lathe of at least 1HP is required for using this product.