Rockler Bench Dog® ProMAX Cast Router Table And Fence Without Plate (40-102)

Expand your table saw’s versatility by adding this industrial grade router table in place of the extension wing. Perfect for shops where space is tight, ProMAX includes a cast-iron top, Bench Dog’s 28″ ProFence, a miter gauge track that adjusts for a no-slop fit. If workspace is an issue, the ProMAX has you covered. Its dual fence slot configuration lets you rotate the fence and work from either side of the table to maximize surface area. Plus, with a third miter slot at its disposal, your table saw becomes perfectly equipped to handle crosscut sleds.

Your table saw needs to be 27” deep and 1-1/2” thick to work with the Rockler Bench Dog® ProMAX Cast Router Table. The holes on the Promax should match at least three holes on your saw or you may need to drill additional holes in the Promax table. The ProMax mounting hole pattern can be found under Technical Downloads.

Notice: ProMAX cannot be installed as a left extension replacement on left tilt “”cabinet”” grade table saws because the table saw’s motor protrudes to the left. Nor can ProMAX be installed as a right extension replacement on right tilt “”cabinet”” grade table saws for the same reason. Mounting ProMAX to the far right will avoid the protruding motors, however, ProMAX must be supported with two steel rails that also support your T-square style rip fence and legs.